Introduction to Swapping

When the physical memory in the system runs out and a process needs to bring a page into memory then the operating system must decide what to do. It must fairly share the physical pages in the system between the processes running in the system, therefore it may need to remove one or more pages from the system to make room for the new page to be brought into memory. How virtual pages are selected for removal from physical memory affects the efficiency of the system.

Swapping is the one of the efficient regular and authentic approach of memory management. It is the process of swapping of higher priority process on the lower priority process.
Advantages of swapping are as follows :-
1. Higher degree of multi-programming.
2. Dynamic relocation.
3. Greater memory utilization.
4. Priority based scheduling.
5. Less wastage of CPU time.
6. Higher performance.

If the page to be removed came from an image or data file and has not been written to then the page does not need to be saved. Instead it can be discarded and if the process needs that page again it can be brought back into memory from the image or data file again. However, if the page has been written to then the operating system must preserve the contents of that page so that it can be accessed at a later time.

Linux uses a page aging technique to fairly choose pages which might be removed from the system. This scheme involves every page in the system having an age which changes as the page is accessed. The more that a page is accessed, the younger it is; the less that it is accessed the older it becomes. Old pages are good candidates for swapping.

Overview of Demand Paging

Demand paging follows that pages should only be brought into memory if the executing process demands them. This is often referred to as lazy evaluation as only those pages demanded by the process are swapped from secondary storage to main memory. Contrast this to pure swapping, where all memory for a process is swapped from secondary storage to main memory during the process start-up.

In pure demand paging a page is never moved from the backing store into main memory until that page is referenced. It is the responsibility of the operating system to check where the page is in main memory and OS uses an internal table for this. Operating system reads that page after finding it, and in order to reflect change, the page table is updated. So by using this process it is possible to run a process even its entire memory image is not taken from backing store into main memory.
In this way demand paging is a better approach then paging and it also increases the degree of multiprogramming and allows a process to run even it exceed the physical space allocated for it.

An invalid page is one that currently resides in secondary memory. When a process tries to access a page, the following steps are generally followed:
- Attempt to access page.
- If page is valid (in memory) then continue processing instruction as normal.
- If page is invalid then a page-fault trap occurs.
- Check if the memory reference is a valid reference to a location on secondary memory. If not, the process is terminated (illegal memory access). Otherwise, we have to page in the required page.
- Schedule disk operation to read the desired page into main memory.
- Restart the instruction that was interrupted by the operating system trap.